ICG placement and its problems

-

 

In order to over the timing problem, while inserting the clock gating, we need to insert the clock gating at the correct  position such that it should not effect the timing.

Even if we the  add the ICG for every flop it leads to more dynamic power 

For example ICG cloning will be happened for every 20 flops  again depends on Technology.

Comments

Post a Comment

Popular posts from this blog

KEEPOUT MARGIN

-
Image
  Keepout margin : This the one of the technique using during placement macros and standard cells in the core area. It is the region around the boundary of fixed cells in a block in which no other cells are placed. The width of the keep-out margin on each side of the fixed cell can be the same or different. Keeping the placement of cells, macros etc.. This technique can  avoids congestion and nets detouring and timings. For the best quality of results. How we decide the margin?  The margin is decided based on the macros or IPs .These macros and IPs will come from vendors its clearly mention in the document regarding the margin around the macros like expected values will be mentioned, by reading the document we can get the values will giving the values we may increase or decrease depend on the problem we faced in the core area. For the std cells, basically we will keep out margin to mainly for AOI ,IOA and Multibit flops etc. Why only AOI, IOA and multibit flops because th...
Read more

ZWL(Zero Wire Load) Why its preferred ?

-
Image
  1) If we provide the Wire details prior to PNR stage then its called wire load Module. ( so we will  provide parasitic information file to the tool) 2) But coming to ZWL we wont provide any wire information to the tool so tool will assume that wire is zero ( we will not provide any parasitic information to the tool). Then how will tool will estimate the parasitic information? so tool will understand that net delay is zero, While checking the Timing from the tool, The tool will pick the cell  net delay from the standard cell libraries. Now we got the extract timing information with respective the standard cells used in the design.  Then how it will be helped in the timing? if you check in the tool by providing with and without parasitic information file you will differ with respective setup time and hold time of a chip.  By doing some analysis with ZWL timing will be clean in setup and hold is under control across the corners. Run time is also fast and implemen...
Read more